Accessing GUI of Brocade SAN Switch without Broswer

Please refer to the steps below to easily accessing the GUI of Brocade SAN Switch without using Broswer

1. Console to the Brocade SAN Switch with default username = admin & Password = password to configure the IP Address

       Warning: Default password not changed for 'root'. Please login as 'root' to change it.
       Please change passwords for switch default accounts now.
       Use Control-C to exit or press 'Enter' key to proceed.
   
       for user - admin
       Changing password for admin
       Enter old password:
       Password was not changed. Will prompt again at next login
       until password is changed.
       SW2:admin> ipaddrset
       DHCP [Off]:
       Ethernet IP Address [10.253.25.233]:10.253.25.233
       Ethernet Subnetmask [255.255.254.0]:255.255.254.0
       Gateway IP Address [10.253.24.254]:10.253.24.254
       SW2:admin>
   

2. Install the latest JAVA version

3. Add the IP Address of the SAN Switch to Exception Site List in JAVA
   

4. Open Command Prompt and enter the following

   javaws "http://10.253.25.233/switchExplorer_installed.html"
   

   Replace the IP Address with the Actual IP of the SAN Switch

5. You can access the GUI Console without using any Broswer now