Accessing GUI of Brocade SAN Switch without Broswer

  • by

Please refer to the steps below to easily accessing the GUI of Brocade SAN Switch without using Broswer

  1. Console to the Brocade SAN Switch with default username = admin & Password = password to configure the IP Address
        Warning: Default password not changed for 'root'. Please login as 'root' to change it.
        Please change passwords for switch default accounts now.
        Use Control-C to exit or press 'Enter' key to proceed.
    
        for user - admin
        Changing password for admin
        Enter old password:
        Password was not changed. Will prompt again at next login
        until password is changed.
        SW2:admin> ipaddrset
        DHCP [Off]:
        Ethernet IP Address [10.253.25.233]:10.253.25.233
        Ethernet Subnetmask [255.255.254.0]:255.255.254.0
        Gateway IP Address [10.253.24.254]:10.253.24.254
        SW2:admin>
    
  2. Install the latest JAVA version

  3. Add the IP Address of the SAN Switch to Exception Site List in JAVA

  4. Open Command Prompt and enter the following

    javaws "http://10.253.25.233/switchExplorer_installed.html"
    

    Replace the IP Address with the Actual IP of the SAN Switch

  5. You can access the GUI Console without using any Broswer now